耀彩网

欢迎光临济南市天桥区昌达卷帘门加工部网站!

联系我们 收藏本站 在线留言

新闻资讯

首页>>新闻资讯电动卷帘门出现故障可检查这些地方
新闻资讯
联系我们
济南市天桥区昌达卷帘门加工部

联系人:刘经理

电话:耀彩网15953131568

网址:耀彩网http://zbfuguang.com

地址:济南市天桥区金牛建材市场

电动卷帘门出现故障可检查这些地方

来源:http://zbfuguang.com 日期:2022-08-23 发布人:
相信有很多使用电动卷帘门客户,多多少少会遇到电动卷帘门出现故障的时候,因此而着急上火.比如电动卷帘门走不动了、出轨等等。今天济南卷帘门厂给大家说下如果电动卷帘门真出现故障,无论是什么故障都可以检查以下方面寻求解决。
It is believed that many customers who use electric roller shutter doors will more or less encounter the failure of electric roller shutter doors, so they are anxious to get angry For example, the electric roller shutter door cannot move and derails. Today, Jinan rolling shutter door factory told you that if the electric rolling shutter door really fails, no matter what the fault is, you can check the following aspects to find solutions.
电机转动速度十分的慢,且走走停停
The rotation speed of the motor is very slow, and it stops and stops
当出现此类现象时,可能是电压不稳、电压过小导致的,请逐步检查电压是否稳定,是否为AC220V±10%50Hz的电压,如果确认电压属于正常范围后依然出现无法正常使用的现象,即可初步断定,是电机或控制系统的问题。
When such phenomenon occurs, it may be caused by unstable voltage or too low voltage. Please first check whether the voltage is stable and whether it is AC220V ± 10% 50Hz. If the voltage is within the normal range and still cannot be used normally, it can be preliminarily determined that it is the problem of the motor or the control system.
检测控制器是否故障的方法就是直接使用遥控器按开关停键,观察控制板上的提示灯是否会亮,如果会亮,则说明控制器正常。
The method to detect whether the controller is faulty is to directly use the remote controller to press the switch stop button, and observe whether the prompt light on the control panel is on. If it is on, it indicates that the controller is normal.
接下来则检测目标就是电机了,电机直接通上220伏的电源,如果会转则说明电机正常。按照此方法分别检测排查,电动伸缩门安装电话,分析故障出现的部位是电机还是控制器。如以上方法依然无效,则说明电机或控制系统使用寿限已尽属于自然老化,需要从新更换。
Next, the detection target is the motor. The motor is directly connected to the 220 volt power supply. If it can rotate, it indicates that the motor is normal. According to this method, the electric telescopic door is installed with a telephone to analyze whether the fault occurs in the motor or the controller. If the above method is still invalid, it indicates that the service life limit of the motor or control system is natural aging and needs to be replaced.
济南卷帘门厂
电机不动,控制盒提示灯不亮
The motor does not move and the prompt light of the control box does not light up
当出现遥控器控制时电机不会转,控制盒上的指示灯也不会亮的状况时,这种现象的发生,要检查的是遥控器电池电源是否耗尽,检查的方法是按下遥控器上的开关停键观察遥控器右上角的提示灯是否会亮(红色灯光),如果不亮,说明电池里的电源经过长期使用以完全耗尽,请直接更换同型号电池即可解决。
When the motor will not rotate and the indicator light on the control box will not be on when the remote controller is controlled, the first thing to check for this phenomenon is whether the battery power of the remote controller is exhausted. The check method is to press the switch stop button on the remote controller and observe whether the prompt light on the upper right corner of the remote controller will be on (red light). If it is not on, it means that the power in the battery is completely exhausted after long-term use, Please replace the battery of the same model directly.
第二个需要排查的地方则是电机输出电源的两根主线(零线/火线)是否接好,有没松掉。是,则固定牢固接好电线即可,如果检查完毕后发现并不是这种现象时,则需要检测整条电源线是否接触不良,断线、电流是否可以正常输送。如检查后发现电线导电异常,则更换一条新的电线即可(电线的规格要伸缩门专用三芯线),电线的接线方法请参考电线更换前。
The second place to check is whether the two main lines (zero line / live line) of the motor output power supply are connected properly and loose. If yes, it is enough to fix and connect the wires firmly. If this phenomenon is not found after the inspection, it is necessary to check whether the whole power line is in poor contact, broken wire and current can be transmitted normally. If the electric wire is found to be abnormally conductive after inspection, replace it with a new one (the specification of the electric wire should be the three core wire for the telescopic door). Please refer to the wiring method before the replacement of the electric wire.
此外阀门卡死导致伸缩门不动,导致的原因可能是反向旋转和限位开关调整得不正确,解决方法是在阀门开启位置时,使用手轮操作中的锤击机构能打开卡死的阀门。更多相关内容就来我们网站http://zbfuguang.com咨询了解吧。
In addition, the valve is stuck, which causes the telescopic door to not move. The reason may be the reverse rotation and the limit switch is adjusted incorrectly. The solution is to use the hammer mechanism in the hand wheel operation to open the stuck valve when the valve is in the open position. For more information, please visit our website http://zbfuguang.com Consult and understand.

阅读/ Recommended reading

快速卷帘门是由电机转动带动门帘上下移动达到开门关门的,而电机是由独立的控制系统来控制的,门的开门高度,关门高度已经开关门的速度都是可以根据需求设置的,快速卷帘门也是属于自动化设备中...

卷闸门在安装时要注意什么? 2024-02-27
自动门水晶卷帘门安装方法介绍 2024-02-23
电动卷帘门常见的故障及维修方法 2024-02-21
电动卷帘门的快速保养与维护 2024-02-10

耀彩网【本站图片均由网站所有方提供,部分图片来源于网络,如无意中侵犯了某媒体或个人的知识产权,请来信或来电告之,本网站将立即删除。】

  • 宏顺卷帘门