很多用户都在反映自己家安装的卷帘门用不了多长时间就会出现各种小毛病，这其实也和自己在安装完之后不注重后期的维护与保养有关系。今天小编给大家讲一下卷帘门日常维护与保养技巧。
Many users are reflecting that the rolling shutter door installed in their home will have various minor defects in a short time, which is actually related to their failure to pay attention to the later maintenance after installation. Today, Xiaobian will tell you about the daily maintenance and maintenance skills of roller shutter doors.
1、在卷帘门的应用过程中，尽量保持控制器和工作电压的稳定，不得设置在非常潮湿的环境中。 又不能随便打开控制器。 如果在门页上缠上电缆，发现不能结合，就要妥善处理。 注意通道是否被堵塞，堵住门后翻页，发生异常反应后马上停止马达的运转。
1. During the application of roller shutter door, try to keep the controller and working voltage stable, and do not set it in a very humid environment. You can't turn on the controller casually. If the cable is wrapped around the door leaf and cannot be combined, it should be properly handled. Pay attention to whether the safety passage is blocked, turn the page after blocking the door, and stop the motor immediately after abnormal reaction.
2、习惯性地检查闸门上下行程的电源开关，给行程控制器补充润滑脂，维持正常优良的动作，另外，实际上由作业人员手动控制电动闸门，检查检查器的动作状况，检查上下限位开关的部位， 快门开闭时要放在适当的位置，在检查中切断快门的碰撞、碰撞和跌倒，发生紧急情况时，停止旋转，切断电源。
2. Habitually check the power switch of the up and down travel of the gate, add grease to the travel controller, and maintain normal and good action. In addition, in fact, the operator manually controls the electric gate, checks the action condition of the inspector, checks the position of the upper and lower limit switches, and places the shutter in an appropriate position when opening and closing. During the inspection, cut off the collision, collision and fall of the shutter. In case of emergency, stop rotating first, Cut off the power supply.

3、作业人员应尽量习惯性地检查闸门的手动式电源开关和手动式升降设计，以免在紧急情况下闸门失灵或发生多余的事故。
3. Operators should habitually check the manual power switch and manual lifting design of the gate as far as possible to avoid gate failure or unnecessary safety accidents in case of emergency.
4、济南卷帘门厂认为您保持轨道运行，立即快门轨道，保持内部清洁，快门马达和链条始终充填润滑液，检查操作箱内部部件和电源开关的操作箱，拧紧配线端口号，拧紧螺钉等，清扫操作箱内、表层和按钮的灰尘废弃物，按钮堵塞。
4. Jinan roller shutter factory believes that you should keep the track running, immediately remove the shutter track, keep the interior clean, always fill the shutter motor and chain with lubricating fluid, check the internal components of the operation box and the operation box of the power switch, tighten the wiring port number, tighten the screws, etc., and clean the dust and waste in the operation box, the surface and the buttons, and the buttons are blocked.
以上就是小编整理的关于卷帘门如何进行日常维护与保养方面的内容。想了解更多知识，欢迎大家关注我们的网站http://zbfuguang.com，有什么问题可随时联系我们咨询。
The above is the content about how to carry out daily maintenance and service of roller shutter door compiled by Xiaobian. If you want to know more, please pay attention to our website http://zbfuguang.com If you have any questions, please feel free to contact us.